Procedure for Applying Semi-Permanent Tattoo Stickers:
- Prepare the Skin: Ensure the intended skin area is clean and dry. Remove any dirt, oils, or lotions from the skin's surface.
- Roll Up the Sticker: Roll the sticker to the clear protective film side. This will make it easier to conform to the curves of your arm or leg.
- Remove the Protective Film: Gently peel away the clear protective film from the tattoo design, taking care not to touch the adhesive side.
- Firm Application: Position the adhesive side of the tattoo onto the clean, dry skin. Press it down firmly to achieve a secure adhesion, ensuring there are no wrinkles or air bubbles beneath the tattoo.
- Wet and Wait: Thoroughly wet the entire tattoo sticker by using a damp cloth or sponge. Hold the damp cloth against the tattoo sticker for approximately 30 seconds to 1 minute, allowing the water to fully saturate the tattoo.
- Gentle Peel-Off: Carefully remove the paper from the tattoo sticker. If the tattoo hasn't transferred completely, gently press it back down and repeat the step Wet and Wait.
- Allow Drying: Once the tattoo is in place, and the paper backing has been removed, allow it to dry for at least 1-2 hours before touching or rubbing it.
-
Please Note: It's essential to avoid any contact with the tattoo ink until it has completely dried, which typically takes about 1-2 hours. Ink will need 24-72 hours to show, so please refrain from any ink contact with other areas of your body until it is fully dry to prevent potential ink transfer, which can be challenging to remove quickly.